Arcam AVR400 User Manual download pdf (Page 4)

Remote input and trigger outputs

ese are for use with Mono jacks and should be wired as the below diagram indicates. Please note: as is typical of this type of remote input external remote eyes such

as a Xantech Dinky Link will require an external +12v regulated power supply as recommended by the supplier.

No RS232 Control

e out of box default setting for the RS232 control port is OFF this can be switched to ON within the General Setup menu it will be seen as the last option under the

heading RS232 control.

Soware update is available from http://www.arcam.co.uk/extranethome/tor

Tricks & shortcuts

Changing the video output resolution from the remote control

Simply press the AMP button on the remote follow by Shi then within 1 sec press the Right arrow – you will see the current resolution display –press Shi and the

Right arrow again and the AVR will move to the next resolution.

is is useful if the AVR output resolution has been set to a resolution that the display device is not compatible with.

Update from USB

On the front panel press Mode + Display then O.K

Display soware version

On the front panel press Info and Volume +

Full reset from front panel

On the front panel press Info and Zone for +3 seconds (AVR will display Standby and then restart)

23425 AVR360/400 — FAQ

Part 4 - CI, tricks & shortcuts