Arcam AVP700 User Manual download pdf (Page 6)

AVP700

E-6

AVP700

E-7

English

Installation

Positioning the unit

Place the AVP700 on a level,  rm surface.

Avoid placing the unit in direct sunlight or near sources of heat or damp.

Do not place the unit on top of a power ampli er or other source of heat.

Ensure adequate ventilation. Do not place the unit in an enclosed space such as a bookcase or

closed cabinet unless there is good provision for ventilation. The AVP700 may run warm, even

during normal operation.

Make sure the IR receiver in the centre of the front panel display is unobstructed, otherwise use

of the remote control will be impaired. If line-of-sight is impractical, an infrared remote repeater

can be used with the rear panel IR connector (this is described later in this handbook).

Do not place your record deck on top of this unit.

Record decks are very sensitive to the noise generated by mains power supplies, which will be

heard as ‘hum’ if the record deck is too close.

Notes on installing the AVP700

The inputs are named to make it easier to reference when connecting source components to the AVP700

(e.g., a DVD or VCR), but all inputs have the same circuitry. This means that there is no reason why you

should not connect a different device from that labelled to any of the inputs. For example, if you had two

DVD players and the AV input was not being used, then the second DVD player could be connected to

the AV input.

Cables

We recommend the use of high quality screened analogue, digital and video cables, since inferior

quality cables will degrade the overall quality of your system. Use only cables that are designed for the

particular application as other cables will have different impedance characteristics that will degrade

performance (for example, do not use cabling intended for audio use to carry video signals). All cables

should be kept as short as is practically possible.

Video and digital connections must be made with cables that are designed for this purpose, i.e., coaxial

cable with a 75Ω impedance. If substandard cables are used you may suffer from poor picture quality

such as ghost images and/or grainy picture quality (snow).

Speaker cables should be kept short to ensure ef cient power transmission and avoid audible distortion.

It is good practice when connecting your equipment to ensure that the mains power supply cabling is

kept as far away as possible from your audio and video cables, as this will provide the best sound and

picture quality. Failure to do so may result in unwanted noise in the audio and video signals.

TAPE

DVD-A IN

OUTPUTS

AUDIO VIDEO DIGITAL IN

REMOTE

RS232 CONTROL

FR FL CEN RS LS RSB LSB

OUT

VCR

OUT

AUX

SAT

DVD

MON

OUT

ZONE2

VIDEO

OUT

DIGITAL

OUT

DVD

SAT

AUX

TAPE

OUT

RSB

CEN

LSB

SUB

RSB

CEN

LSB

SUB

ZONE

LOCAL

OUT

1/RGB 2/S-VID

12V

TRIGGER

(Z1 & Z2)

VIDEO TRIGGER

INLET

DVD

OUT

SAT

GND

HIGH QUALITY VIDEO IN

(USA) 10K

(EU) 9K

AM STEP

230

GROUND

LIFT

GROUND

SUB

DVD

SAT

OUTIN

HDMI

The AVP700 rear panel

1 2 3 4 5 6 7 8 9 10 11 ... 42 43

Comments to this Manuals

No comments

Arcam AVP700 User Manual Page 6

Comments to this Manuals

Related products and manuals for AV receivers Arcam AVP700