Arcam SOLO MOVIE 2.1 Operations Instructions download pdf (Page 10)

E-10

The performance of your system can be enhanced by

organizing separate ampliﬁcation for the low and high

frequency drive units in each loudspeaker enclosure. This

is called ‘bi-amping’.

Important – before you start

1. Do not make any connections to your Solo Movie

2.1 while it is switched on or connected to the

mains supply.

2. After connecting the loudspeakers, but before

switching on Solo Movie 2.1, please check all

connections thoroughly. Make sure bare wires

or cables are not touching the unit in the wrong

places (which could cause short circuits) and that

you have connected positive (+) to positive and

negative (–) to negative.

3. If your speakers are bi-wirable (i.e. they have

positive and negative terminals for both

high frequency (HF) and low frequency (LF)

information), ensure that the links between

the HF and LF terminals are removed.

Using an external power-amplifier

to bi-amp your front speakers

To bi-amplify the front left and right channels, a two-

channel ampliﬁer such as the Arcam P90 is required (as

shown on the adjacent diagram).

Connect the pre-ampliﬁer outputs of the Solo Movie 2.1

to the line inputs of the power ampliﬁer.

WARNING: You must remove any terminal links

on your speaker before connecting an ampliﬁer or you

may damage your Solo Movie 2.1. Such damage is not

covered under warranty.

Now connect the

HF terminal of your speaker to the

correct speaker terminal of the Solo Movie 2.1 (the Solo

Movie 2.1 ampliﬁcation circuits will be used to provide

the high-frequency signals); connect the LF terminal of

your speaker to the correct speaker terminal of the

power ampliﬁer (the power ampliﬁer will be used to

provide the low-frequency signals).

Ensure that in all cases, the positive terminals on the

speakers are connected to the positive (red) terminals

on the ampliﬁer, and similarly for the negative (black)

terminals.

bi-amping your front loudspeakers































































Bi-amping using Solo Movie 2.1 and a P90 ampliﬁer

Right speaker

Left speaker

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Comments to this Manuals

No comments

Arcam SOLO MOVIE 2.1 Operations Instructions Page 10

Comments to this Manuals

Related products and manuals for DVD players Arcam SOLO MOVIE 2.1